Fanuc O Series Models A, B, C and D

Parameters (SETTINGS 1)

  • Select MDI mode.
  • Press the DGNOS/PARAM hard key.
  • Press the PARAM soft key.
  • Press the PAGE down hard key once or until the 'SETTING 1' page is displayed.

TVON 0
ISO 1(ISO)
I/O 0 or 1

Machine Parameters

To make any changes to the machine parameters you must enable Parameter Write Enable (PWE). Always backup parameters before making any changes.

  • Select MDI mode.
  • Press the DGNOS/PARAM hard key.
  • Press the PARAM soft key.
  • Press the PAGE down hard key once or until the 'SETTING 2' page is displayed.
  • Change PWE from 0 to a 1. The control will enter an alarm state, this is normal. Change back to 0 when finished and press the Reset button to clear alarm.

Suggested Parameters

To change parameters

  • Select MDI mode.
  • Press the DGNOS/PARAM hard key.
  • Press the PARAM soft key.
  • Select parameter to change.

Suggested Parameters settings:

Parameter Number Description Recommended Value
2- Bit #0(STP2) Number of Stop Bits when I/O Channel = 0
0=1, 1=2 		1
2 - Bit #2(ASR33) RS232 Interface is used when I/O Channel = 0 0
2 - Bit #7(NFED) Feed before and after output when I/O Channel = 0
0=Yes, 1=No 		1
552 (BRATE0) Baud Rate when I/O Channel = 0
See Table 		11
12- Bit #0(STP2) Number of Stop Bits when I/O Channel = 1
0=1, 1=2 		1
12 - Bit #2(ASR33) RS232 Interface is used when I/O Channel = 1 0
12 - Bit #7(NFED) Feed before and after output when I/O Channel = 1
0=Yes, 1=No 		1
553 (BRATE0) Baud Rate when I/O Channel = 0
See Table 		11

SharpEdit Settings:

Fanuc 0 Settings

How to send and receive

Sending to machine

Make sure the Edit lock key is set to enable, if fitted.

  • At the machine, select Edit mode.
  • Press the PRGRM hard key until either the current program in the memory is displayed or the program directory screen appears.
  • Press the INPUT hard key. LSK will be flashing in the bottom right hand corner.
  • At SharpEdit press the button to send the Nc code.

Receiving from machine

  • At SharpEdit press the button and SharpEdit will be waiting to receive.
  • At the machine, select Edit mode.
  • Press the PRGRM hard key until either the current program in the memory is displayed or the program directory screen appears.
  • Press the letter O followed by the program number to send.
  • Press the OUTPT/START hard key to send.
  • At SharpEdit, when Bytes Received has stopped increasing, press the Finished button.